Page History
...
The following screen lists the path to the Studio repository for backup purposes. For more information see backup the repository.
If you added a license during the installer it will show the dialog on the left. Otherwise the dialog on the right.
By default Blueriq will be launched when you finish the installation.
Custom installation
The steps in this section apply to the custom installation.
In this screen you can choose the Blueriq features you wish to install: Studio, Runtime, Customerdata, DCM-lists, CaseEngine and Document Renderer. Note that the latter three are only available if you install the Runtime.
Here you can also configure the Blueriq installation directory.
When you click next you can configure the port IIS uses. Default is 150.
| Note |
|---|
Any port specified in the installer is not checked for availability. |
When you click next you can configure the port of the Studio Server service uses and the port for the studio Rest Service. Defaults are 14093 15093 and 1409615096.
If the checkbox "Start studio on install" is checked the Studio will be started after the installation is finished.
When you click next you can configure the ports of the PostgreSQL Service and History Service. Defaults are 14094 15094 and 1409515095.
These Services are use by the version management system.
The next screen allows you the choose the type of authentication that Studio will use. For more information and configuration after installation see security and user management.
Next is the user that is used to connect to Blueriq Studio by the administration page. The default is listed.
| Note |
|---|
if you choose NTLM or NTLM custom for security configuration, you need to provide an active directory user here. If you choose custom authentication, you best leave this untouched. If you need to change the user, the configuration for the administration page will be changed, but you still need to manually create the user in Studio after installation. Without this, the administration page will not function. |
When you click next the port that the Runtime uses is asked. The defaults are 15091.
If the checkbox "Start runtime on install" is checked the Runtime will be started after the installation is finished....
When you click next the port that Document Renderer Service uses is asked. The defaults are 15099.
If the checkbox "Start document renderer on install" is checked the Document Renderer service will be started after the installation is finished.
After this you are ready to install.
During installation a progress bar is shown.
If you added a license during the installer it will show the dialog on the left. Otherwise the dialog on the right.
By default Blueriq will be launched when you finish the installation.
Installation finished
When the installation is finished, the Blueriq start page is launched. Note that you first have to put the license file in the right location before you can start anything. For that and other configuration please take a look at Studio.
Configuration
After installation is finished, continue to configuration of Studio and/or Runtime.
Logging
The installer will always save a log file during install on the location : %appdata%\Blueriq\
In case of an error during installation the log could give you more information about the cause of the error.
Common installation problems
| Content by Label | ||||||||
|---|---|---|---|---|---|---|---|---|
|
...
Overview
Content Tools