Versions Compared

Old Version 14

changes.mady.by.user Tijmen Daatselaar

Saved on

compared with

New Version 15

changes.mady.by.user Ferdy van Varik

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

The steps in this section apply to the custom installation.

In this screen you can choose the Blueriq features you wish to install: Studio, Runtime, Customerdata, DCM-lists, CaseEngine and Document Renderer. Note that the latter three are only available if you install the Runtime.
Here you can also configure the Blueriq installation directory.

A Studio/Encore user named admin will be created during the installation. To do so, a valid password needs to be entered here.  

An admin user for the user management in Keycloak of Studio/Encore will also be created during the installation. To do so, a valid password needs to be entered here.  

When you click next you can configure the port IIS uses. Default is 160. 

Note

Any port specified in the installer is not checked for availability.

When you click next you can configure the port of the Studio Server service uses and the port for the studio Rest Service. Defaults are 16093 and 16096.
If the checkbox "Start studio on install" is checked the Studio will be started after the installation is finished.

When you click next you can configure the ports of the PostgreSQL Service and History Service. Defaults are 16094 and 16095.

These Services are use by the version management system.

The next screen allows you the choose the type of authentication that Studio will use. For more information and configuration after installation see Studio Security Modes.

Image Removed

When you click next the port that the Runtime uses is asked. The defaults are 16091.

If the checkbox "Start runtime on install" is checked the Runtime will be started after the installation is finished.

...